|
|
|
|
|
G23 Cool Head - Heat sink for G23 Go-ped® engines - Mounts on top of cylinder - Reduces head temperature by approximately 40 degrees - Helps guard against engine fade - Very easy to install - just cut top of engine cover and screw into top of cylinder - Available in Clear, Black, Blue, Green, Purple and Red Billet Aluminum - Comes complete with cool head, screw, and instructions - Now only $39.95 |
|
|
G230RC Cool Head - Heat sink for G230RC Go-ped® engines (Super Models) - Mounts on top of cylinder - Reduces head temperature by approximately 40 degrees - Helps guard against engine fade - Easy to install - Drill & tap cylinder - Available in Clear, Black, Blue, Green, Purple and Red Billet Aluminum - Comes complete with cool head, screw, and instructions - Now only $42.95
Install Kit for G230RC Cool Head - Includes drill bit, drill guide, & tap - This kit is not necessary if you have a drill bit & tap, using the cool head as a guide - Only $10.00 |
|
|
Case Stuffer - Case stuffer for G23 (angle plug) Go-ped® engines - Major horsepower gain from low rpms to full throttle - Reduces crank case volume & Smooths and speeds up fuel/air flow (means you go faster!) - Easy to install - split crank case & install around crank - A must have! - Now only $35.95
|
|
| Remote
Needle Control - Adjust your carb mixture while riding your ped (Get real time results while ped is in use) - No more stopping to readjust carb screws - Works on a G23LH engine with HP carb, G2D, and G230RC engines - Includes 2 piece billet clamp, billet knob, stainless steel housing cable, billet needle holder, and needle spring
$89.99
|
Warning: This can and will blow up your engine if not used correctly. Please read all directions included before use.
|
| X-Port - Increases low end torque - Lowers pipe, muffler and cylinder temperatures - Fits all engines - Use on stock muffler, X-Can, and some pipes (not JetPro) - Add a x-port to a Q-can and you can re-route the tube back into the frame for even less noise - Each kit comes complete with instructions, hardware, and gaskets - For use on the Sport®/Bigfoot®/X-Ped®/Liquimatic®/Go-Quad®/Super X-Ped®/Super Bigfoot®/Super Go-Quad®
$25.00
|
|
| Rockit Key
w/Puller Bolt - Advances your timing 10 degrees - Increases your acceleration (gain up to 2 mph on top speed) - Cheapest way to speed up your ped! - Works on G23 and G2D engines (not recommended for G230RC engines) - No guessing if you advanced your timing correctly or not - Replaces stock flywheel key - Each kit comes complete with instructions and hardware - For use on the Sport®/Bigfoot®/Liquimatic®/Go-Quad®
Only $7.95!!!
|
Click here to bookmark our site.
Copyright © 1999, 2000, 2001, 2002. GETaPED.com, Inc. All rights reserved.
